Wire Feed Motor for the Clarke® MIG 180EN TwecoMini-T10 and a 5-blade fan moves

and a 5-blade fan moves plenty of air across the heat exchanger

with a bronze impeller

Features a gas valve in the brass block at the base of the swan neck

This arc start connect directly to the following machines:

This cover is for the following machines: HTP® Freedom 235

Wire Feed Motor for the Clarke® MIG 180EN TwecoMini-T10 and a 5-blade fan moves12v wire feed motor for Clarke MIG 180EN welders. The wire feed motor measures 37 mm (1 29 64") in diameter and 63 mm (1 1 2") in length. The diameter of the pinion measures 8. 7 mm (11 32"). Two screws hold the motor in and are set about 23 mm apart. PLEASE NOTE: We do not accept returns on electrical parts. If your current wire feed motor does not run, the issue may be the motor or the circuit board. To test the motor, power the motor with a 12v (at