Mitre Guillotine Rebate Supports rebate Replacement pneumatic clamping cylinder used

Replacement pneumatic clamping cylinder used to hold the moulding whilst its being cut

The Cs486 control panel shows the error code E3 when this proximity sensor is faulty

Positioned in the top of the Morso eh hydraulic oil tank to filter out any contaminants that could damage the (very expensive) control valves

please ensure you order the correct one for your machine

Steel lever that locks the Cs810 vertical clamp shaft in the down position

Mitre Guillotine Rebate Supports rebate Replacement pneumatic clamping cylinder usedReplacement pair of rebate supports that are compatible with Morso, Hansen, Charnwood, Framers Corner mitre guillotines. Rebate riser has an extra extended rising height of 0 50mm Hard wearing Stainless Steel is used to manufacture the rebate guides, threaded shaft, rebate risers, wear pads and knurled thumb collars. The rebate body is made from a composite material incorporating carbon fibre for added strength. Rebate riser uses two securing points